ER Optimus wheel removal?
Posted: Sun Nov 07, 2021 5:09 pmHey everyone!
Sorry if this isn't appropriate for starting a new thread, buts it's such a specific question it seemed the best way
So the short of it is, I'd like to paint the light grey plastic on Earthrise Prime, most of it is located on the legs so I thought gee might as well pop the wheels off to get back under the wheel well good. They do seem to be on mushroom pegs, so in theory shouldn't be a problem to pop em off, except they're on there REEEALLY firmly and rather than Test My Luck figured I would ask and see if anyone here has had an experience doing this very thing, just to be sure I don't explode my Prime
Thanks in advance for any and all discussions!
Edit:
Welp, while y'all where having cat fights about 3D printers I managed to get the wheels off in a normal fashion Disregard this post!
Sorry if this isn't appropriate for starting a new thread, buts it's such a specific question it seemed the best way
So the short of it is, I'd like to paint the light grey plastic on Earthrise Prime, most of it is located on the legs so I thought gee might as well pop the wheels off to get back under the wheel well good. They do seem to be on mushroom pegs, so in theory shouldn't be a problem to pop em off, except they're on there REEEALLY firmly and rather than Test My Luck figured I would ask and see if anyone here has had an experience doing this very thing, just to be sure I don't explode my Prime
Thanks in advance for any and all discussions!
Edit:
Welp, while y'all where having cat fights about 3D printers I managed to get the wheels off in a normal fashion
Disregard this post!